Scanner Beeps but does not Display Data/Not Connected Error
Problem: When scanning a 2D barcode, the scanner beeps, but the data is not being displayed.
Possible Cause: This could be caused by the scanner not connecting when the application starts up. This usually results the software showing “Not Connected” in the lower right hand corner of the screen.
Solution: Reconnecting the Barcode and/or Magnetic Stripe Scanner to the AgeVisor Software.
Step 1: Click on the Connection button in the Settings tab
Step 2: Check the boxes next to POS HID Scanner Enable and MSR Magstripe Enable.
NOTE: If you have an AgeVisor Touch that ONLY scans barcodes, please only check POS HID.
Only if Magnetic Stripe reader equipped: If the COM port for M260/MSR Port is COM1 change it to be the other option (typically COM3).
Press the following buttons in order if using an AgeVisor Touch w/ a Barcode Reader and Magstripe reader:
- Connect MSR
- Config MSR
- Connect POS HID
- Config/Test Scanner
Press the following buttons in order if using an AgeVisor Touch w/ a Barcode Reader only:
- Connect POS HID
- Config/Test Scanner
Click Here if you receive a M430/M420 Communications Timeout Error.
After reconnecting the scanner(s) check the box for Automatic Port Open then press Save/Exit.
Step 3: Go back to the Main tab and ensure the software show “Scanner Connected” on the bottom right hand corner of the screen.
Scan an ID.
If it correctly displays the information, then the issue should now be solved.
If after attempting these steps you are still unable to resolve your issue please create a support ticket leaving your Name, Business name, Phone, and email address here.